Motors and Flying

12 articles

Why does my CoDrone EDU controller screen say “Motor Stalling”?

If your controller displays a “MOTOR STALLED” message, it means an electric motor is receiving power but cannot rotate due to excessive load then leading to a jammed mechanism that ultimately causes…

Updated by Robolink Support

Why does my CoDrone EDU controller screen say “motion calibrating” when I try to take off?

Holding down the top-left shoulder button on the controller sends the takeoff command to CoDrone EDU. However, if the drone is unable to take off, you may see a “Motion Calibrating” message, “Calibra…

Updated by Robolink Support

My CoDrone EDU sometimes flies straight up to the ceiling during autonomous flight. What's going on?

Last updated: June 17, 2025 If your CoDrone EDU suddenly launches straight up to the ceiling when running autonomous code, this behavior has been observed in early firmware versions of the drone and…

Updated by Robolink Support

How do I take care of CoDrone EDU motors?

Important: CoDrone EDU motors are not designed to be repaired through soldering. This includes attempting to solder motor wires back together or reattaching the motor socket to the PCB. Regardless of…

Updated by Robolink Support

What do I do if one of my CoDrone EDU propellers isn't spinning?

If you attempt a takeoff and notice that one or more propellers aren’t spinning, the drone may automatically shut down its motors to prevent unsafe flight. You may also see an error message on your c…

Updated by Leila Firestone

How do I replace the motors on my CoDrone EDU?

Important: CoDrone EDU motors are not designed to be repaired through soldering. This includes attempting to solder motor wires back together or reattaching the motor socket to the PCB. Regardless of…

Updated by Leila Firestone

How do I replace the propellers on my CoDrone EDU?

Propellers may need to be removed from your CoDrone EDU to clear out debris or replaced if they are bent, chipped, or cracked. Damaged propellers can affect flight performance and should be replaced…

Updated by Robolink Support

How do I stop my CoDrone EDU from drifting?

If your CoDrone EDU is drifting during flight, this is a common issue that can usually be fixed with a few simple checks and adjustments. Below are the most common causes and what you can do to fix t…

Updated by Robolink Support

My CoDrone EDU controller screen says “attitude not stable, place on flat surface” when I try to take off.

Holding down the top left shoulder button (L1) on the controller will send the takeoff command to CoDrone EDU. However, if your drone is having trouble taking off, you might see this message: "[Attit…

Updated by Robolink Support

Why are my propellers spinning on my CoDrone EDU but the drone is not taking off?

If your drone's propellers are spinning but it’s not lifting off the ground, there are a few common causes to check. Follow the steps below to identify and resolve the issue: Check propeller and moto…

Updated by Robolink Support

What do I do if my CoDrone EDU motor base is broken?

Important: CoDrone EDU motors are not designed to be repaired through soldering. This includes attempting to solder motor wires back together or reattaching the motor socket to the PCB. Regardless of…

Updated by Robolink Support

Why does my CoDrone EDU motor spin when I insert a battery into the drone?

If one or more motors on your CoDrone EDU begin spinning immediately after inserting the battery without any input from the controller or code this may indicate a critical issue with the drone’s circ…

Updated by Robolink Support

Powered by HelpDocs (opens in a new tab)

Powered by HelpDocs (opens in a new tab)