Pairing and Programming

9 articles

What do I do if my remote paired with another CoDrone Pro/Lite?

My remote connected with a CoDrone Pro that was nearby, but now it won't connect to the one it came with. What do I do! If your remote has connected to another CoDrone Pro and you are unable to pair…

Updated by Robolink Support

How do I pair my CoDrone Pro/Lite in Python?

First, make sure your computer is set up for pairing with CoDrone Pro/Lite. This includes installing Python, installing an IDE such as PyCharm, installing a driver, and installing the CoDrone library…

Updated by Leila Firestone

Why is my CoDrone Pro/Lite code skipping some blocks?

If you are running code in Blockly and you notice that some blocks are skipping, you may need to add a wait block. A wait block can be found in the "Timing" section of CoDrone Pro/Lite Blockly.

Updated by Robolink Support

My CoDrone Pro/Lite won't pair even though the Bluetooth board is powered on. Why can't it connect?

Before running your program, make sure that the light on the Bluetooth board is blinking red. If it is blinking amber or green, hold down the reset button until the light turns red or try unplugging…

Updated by Robolink Support

Why won't my CoDrone Pro/Lite stop flying after completing my program?

If your CoDrone Pro/Lite stops flying after completing your program, make sure that you have added a drone.land() at the end of your program to ensure that it lands after all other commands have been…

Updated by Robolink Support

Why won't my CoDrone Pro/Lite run again after running the code in Python?

If your CoDrone Pro/Lite won't run your program after running it the first time, make sure that you include a drone.close() at the end of your program to ensure that the CoDrone Pro/Lite disconnects…

Updated by Robolink Support

How do I pair my CoDrone Pro in Arduino?

The CoDrone Pro/Lite can be paired in Arduino using the pair() command found in the documentation library here. With the Arduino-based remote, pair() with no parameters will pair with the last paired…

Updated by Robolink Support

Can I program my CoDrone Pro with the Arduino Web Editor?

Due to the Arduino Web Editor only supporting certain Arduino boards, you will not be able to program your CoDrone Pro using the Arduino Web Editor and must install the Arduino IDE on your device. Pl…

Updated by Robolink Support

What does the message "ERROR: Could not open the USB serial port" mean? (CoDrone Pro/Lite)

>> ERROR: Could not open the USB serial port >> Please check if the CoDrone Bluetooth module is connected >> and verify you have the USB Driver (add a link to the lesson) >> Closing program If you re…

Updated by Robolink Support

Powered by HelpDocs (opens in a new tab)

Powered by HelpDocs (opens in a new tab)